LifanForum.com
Lifan Motorcycle, Scooter And ATV Forum

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - uglydog

Pages: 1
1
LF250 / Re: LF250 Poor Running
« on: October 16, 2008, 02:11:16 PM »
Thanks everybody for your help and interest. Unfortunately I have not been on the site for a while, and there are now some new ideas here for me to try if the problem is still there.
However, during the summer I thought I had run out of options along the carb route, and fitted new leads, plug caps, and re-routed the fuel line and installed a shorter fuel filter such that the fuel was effectively running down hill to the fuel pump from the fuel tank. I am pleased to report that this was an instant cure for all the previous problems.
As the weather is now getting colder it will be interesting to find out if any cold weather problems begin to develop again.

2
LF250 / Re: LF250 Poor Running
« on: January 10, 2008, 02:25:00 PM »
Since the last post I have stripped and cleaned the carb. which has at least made the bike rideable, but I am still having a problem with idling.

If the throttle has been shut, the engine will try to die, if not idling very very slowly. Sometimes it will cut out, but when restarted it will idle perfectly normally.

Does anyone have any ideas how to solve this?

Thank you very much

3
LF250 / Re: LF250 Poor Running
« on: January 02, 2008, 02:21:25 PM »
The bike has covered 1300Km from new.

Icidentally, I have just tried disconnecting the vacuum pipe where it connects to the connection between the rear cylinder and the caburettor. when the engine side was blocked (covered with finger), the bike ran perfectly on tickover, and revved without any problems at all.
With the vacuum pipe reconnected it still ran fine. Is there anything which could upset this vacuum system when the choke is used?

4
LF250 / LF250 Poor Running
« on: January 02, 2008, 01:18:59 PM »
Can anyone help?
I bought an LF250 in October Last year, and quite frankly I love the bike to ride, as it is so comfortable, but mechanically this bike has been a nightmare.
1 month after buying it I had to replace all of the pipe clips as the old ones were leaking, and letting air into the fuel system, and causing poor running., but it still would not run right.
Out of final frustration I then took it back to the importer in England, who replaced the complete fuel system, which then made it run lovely.
However recently I hvae again expereienced running problems:
1) When cold the bike starts on choke but will not rev, but if not tool cold it will start without choke, and then runs fine.
2) I have tried adjusting the mixture, 1/2 turn in which seemed to remove a slight flat spot, but trying to run the bike tonight, I have found once again the bike would not rev when cold on choke (but started and ran on tickover with choke when cold no problem).
When taken for a run once off choke, it kept trying to cut out as soon as the throttle was closed, and having checked the plugs when i got home they were very sooted as if the bike was running rich, but the carb have notbeen touched since the last time it was used when it ran no problem at all. The only difference tonight is that the temperature is approx 2º C, whereas last time the bike was used it was about 8ºC. Does anybody know of choke problems etc, as i am coming to the end of my tether with this bike, which I have had nothing but hassle with from new?
Any other suggestions apart from putting a match to it are gladly welcome!

Pages: 1