LifanForum.com
Sport Bikes => LF200 => Topic started by: roquesanteira on February 11, 2009, 02:40:49 PM
-
Hello everybody.
I have a new LF 200 III with only 3000 Km. I could not have accelerated to any more than 80 Km/h. The revolutions per minute do not pass of 5500. Someone can indicate me how to arrange this?
Thak's
-
Did you ever find your answer?
-
Did you ever find your answer?
No, i still have this problem
-
What set up do you have? There was a time when I had a similar problem...The engine felt like the choke was on full at around 5500 RPM. For me this was an easy fix.
-
Thank's Ace. I dont know if this can be a carburator problem or front/rear sproket relation. I don't know too much of motorcycles.
-
If the bike dont have enough power for the gearing or weight a engine wont fully rev out. I remember 5th gear top speed rpm was a thousand or 2 lower than 1st gear top rpm due to not having enough power. See how high it revs in nutrual. Thats how high it should be able to hit in at least 1st/2nd gear.
If you geared it taller for higher top speed that will cause your rpms to not go as high as they could because lack of power to pull that gearing. Stock gearing the bike cant even fully pull 5th gear out. And the rev limiter says to 12,000rpm thats just for show that engine is not capable of reving that high its top rpm is only around 7000-8000 I cant remember because after all they use a cloned honda xr200 dirt bike engine.
-
Ok, Thank's i will see.